Loading ...
Loading ...
Loading ...
!
32
If malfunctions or faults occur when a programme is running, the indicator light that
corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will
sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent
and that the siphon or filters are not clogged, set the selected program again.
If the fault persists, contact the Technical Assistance Centre.
FAULTS
CAUSE
SOLUTION
1. No programme
works
Plug not connected to wall socket
Connect electric plug
O/I button not pressed
Press button
Door is open
Close door
No electricity
Check
2. Dishwasher
does not fill
with water
See point 1
Check
The water tap is closed
Open the water tap
The water supply hose is bent
Eliminate the bends in the hose
The filter of the water supply
hose is clogged
Clean the filter at the end of the
hose
3. Dishwasher
does not
discharge water
Filter is dirty
Clean filter
Drain pipe is bent
Eliminate the bends in the pipe
The drain pipe extension is not
correctly connected
Follow the instructions for connecting
the drain pipe carefully
The outlet connection on the
wall is pointing downwards not
upwards
Call a qualified technician
4. Dishwasher
discharges
water
continuously
Position of the drain pipe is too
low
Lift drain pipe to at least 40 cm
above floor level
Only models without a display
This dishwasher is equipped with an overflow safety device that, in the event of a
problem, automatically discharges any excess water.
WARNING
To ensure the correct operation of the overflow safety
device, we recommend not moving or tilting the dishwasher
during operation. Should it be necessary to tilt or move the
dishwasher, please ensure that the washing cycle is
complete and that no water remains inside the appliance.
Other faults
Loading ...
Loading ...
Loading ...