Loading ...
Loading ...
Loading ...
!
30
18.
WATER SOFTENER UNIT
Depending on the source of the supply,
water contains varying amounts of
limestone and minerals which are deposited
on the dishes leaving whitish stains and
marks. The higher the level of these
minerals present in the water, the harder
the water is.
The dishwasher is fitted with a water
softener unit which, through the use of
special regenerating salt, supplies softened
water for washing the dishes. The degree of
hardness of your water can be obtained
from your water supply company.
Hardness of up to 90°fH (French grading) or
50°dH (German grading) through 6 different
settings. The table below lists different
degrees of water hardness with the
corresponding setting for the softener unit.
Level
Water
hardness
Use of
Regenerating salt
Programme
Indicator Light
ºfH
(French
grading)
ºdH
(German
grading)
S0
0-5
0-3
NO
No indicator
lights
S1
6-15
4-9
YES
P1
S2
16-30
10-16
YES
P1+P2
*S3
31-45
17-25
YES
P1+P2+P3
S4
46-60
26-33
YES
P1+P2+P3+
P4
S5
61-90
34-50
YES
P1+P2+P3+
P4
+P5
* The water softener unit is set in the
factory at level 3, as this is suitable for
the majority of users.
According to the degree of hardness of your
water, regulate the softener unit in the
following way:
1. Turn on the dishwasher by pressing the
"ON/OFF" button.
2. Press the "Progr." and "ON/OFF"
buttons at the same time, and hold for 5
sec.
3. A short audio signal will sound and all
the indicator lights will flash for 5 sec.
4. The "PROGRAMME SELECTION"
indicator lights will come on to show
lime scale remover levels. If no indicator
lights come on, level "S0" will be set.
5. Press "Progr." again to select the
desired level of lime scale removal:
every time you press the button, the
corresponding indicator light will come
on, as shown in the table above
(P1" S1, P2" S2,...) For level "S0", all
the lights will be out.
6. Turn off the dishwasher by holding
down the "ON/OFF" button for 3 sec.
to make the new setting effective.
Regulating the water softener
The dishwasher must ALWAYS be off
before start of this procedure.
WARNING!
If any problem occurs, turn the
dishwasher off by pressing the "ON/OFF"
button and start the procedure again
from the beginning (STEP 1).
Loading ...
Loading ...
Loading ...