Loading ...
Loading ...
Loading ...
23
CARING FOR YOUR DRYER
Emptying the water collection tank
During the drying cycle steam condenses into water and is
collected in the water tank, located at the top left of the dryer.
It is important to empty the water tank after every load.
There is an indicator light that will illuminate when the water
tank needs emptying. A user warning will also be displayed on
the screen (refer to the ‘Before you call for service’ section). If
the water tank becomes full during operation, the dryer will go
into ‘Cool’ mode for several minutes, then pause and beep to
alert you. Empty the tank and touch to resume the cycle.
Note: you do not need to empty the water tank if you have set
up the drain hose to drain the water automatically.
To empty the water tank:
1
Remove the water tank by holding onto the handle and pulling
outwards gently to remove it. Ensure that you keep the tank
level when it is being removed to prevent the water collected
from spilling.
2
Pour the water down the sink or into a bucket, and then put
the tank back in place.
z
If the water tank becomes full, the tumble dryer will pause drying and will sound an
alarm. You must empty the water tank before the dryer can continue drying. Empty
the tank, replace it back in the housing then touch to resume the cycle.
Cleaning the condenser
If the ‘Condenser’ indicator light starts to flash this
indicates that the condenser needs to be cleaned. The
condenser should be cleaned after every 100 drying hours.
The light illuminates when you first turn the machine on,
then turns off once the button has been touched.
To clean the condenser:
1
Switch off the power supply and remove the power plug
before cleaning the condenser.
2
Open the condenser cover.
3
Turn the two condenser lock levers 90 degrees then pull
out the condenser.
4
Clean the condenser with pressurised water and wait until
the water drains.
5
Replace the condenser.
6
Turn the two condenser lock levers to lock the condenser
back in place again. Make sure that these locks are
engaged securely.
7
Close the condenser cover.
Pulling out the
condenser
Turning the condenser
locking levers
Removing the
water collection tank
Tipping out the water
condensing tank
Loading ...
Loading ...
Loading ...