Loading ...
Loading ...
Loading ...
11
2. To spray in an upward direction, the angled end of the
suction tube should be pointing toward the rear of the gun
(Fig. 12).
mWARNING! Never tilt the sprayer at an angle greater
than 45°. Material could get into the turbine and damage
the sprayer.
Change the Nozzle Tip
The machine comes with 3 nozzle tips:
• White – 1.5 mm orice. Pre-assembled in the gun
• Black – 1.8 mm orice. Packed separately
• Red – 2.2 mm orice. Packed separately
When selecting the appropriate nozzle tip for a specic job,
consider the spray material you will be using. Generally,
heavier coatings will require a larger orice size than lighter
ones. For example, primers are usually thicker than the
accompanying paint so you should use the black 1.8 mm
tip to prime most surfaces. Most painters will stay in the
range of 1.2 mm to 2.0 mm unless the paint being applied
is specialized.
To change the nozzle tip, follow the instructions below:
1. Make sure the tool is switched o and the battery is
removed from the compartment.
2. Unscrew and remove the tip collar slowly, be careful that
the small parts may fall out, and remove the nozzle tip
inside (Fig. 13).
3. Assemble the desired nozzle tip by aligning the 4 tabs on
the tip with the notches on the sprayer and inserting the
middle needle in the middle hole of the nozzle tip. Press
rmly until the nozzle tip sit securely in position. Replace
the tip collar and tighten securely (Fig. 14).
Adjusting the Spray Patterns
The spray pattern shape can be adjusted by turning the ears
of the air cap to either the vertical, horizontal, or diagonal
positions. The positions of the air cap and the corresponding
spray pattern shapes are illustrated below (Fig. 15).
Test each pattern and use whichever pattern is suitable for
your application.
Fig. 11
Suction tube
pointing
forward
Fig. 12
Suction tube
pointing to
rear
Fig. 13
Tip collar
Nozzle tip
Fig. 14
Tab
Notch New nozzle tip
Tip collar
Loading ...
Loading ...
Loading ...