Loading ...
Loading ...
Loading ...
19
STEP 2 - CONNECT TO A GAS SUPPLY LINE
(GAS DRYER ONLY)
NOTE: Do not connect the dryer to an LP gas line without rst converting the
dryer with a conversion kit. An LP conversion kit must be installed by a qualied
technician.
NOTE: Apply a pipe-joint compound that that is resistant to the action of LP gas to
all males threads. Do not use plumber’s tape.
1. Turn the gas supply o by moving the shuto valve to the closed position.
a Closed Valve
b Open Valve
A
B
2. Disconnect and discard old exible gas connector. Replace with a new CSA(AGA)
approved exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a ⅜" NPT elbow to the gas inlet pipe on the dryer. Then connect a are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
a Gas Inlet Pipe on
the Dryer
b ⅜" NPT Elbow
c ⅜" NPT Flare Adapter
A
B
C
5. Connect the dryer to the gas supply line with a exible gas connector.
a Flexible Gas Connector
A
6. Tighten the exible gas connector using two adjustable wrenches.
Loading ...
Loading ...
Loading ...