Loading ...
Loading ...
Loading ...
21
|
EN
SETUP
Cable Management
The included cable management cover can hold all permanent cabling in place against
a wall.
F
G
H
Small drywall anchor (2)
Small flathead screw (2)
To install the cable management cover:
1. Place and hold the back of the cable cover (F) (the piece with the screw holes)
against desired location on wall.
2. Mark the center of the two screw holes on wall, and remove the back of the cable
cover.
3. If that part of the wall has a stud behind it, drill two 2.4mm (⁄in) holes into the
wall.
If that part of the wall has no stud behind it, drill two 5mm (⁄in) holes into the
wall.
4. If that part of the wall has no stud behind it, drive the two small drywall anchors
(G) into the wall.
5. Align the back of the cable cover (F) with the screw holes.
6. Drive the two small flat-head screws (H) into the back of the cable cover to secure
it to the wall.
7. Gather the cables and place along the “guide” of the back of the cable cover (on
the wall).
8. Remove the adhesive strip from the cable cover foam (F).
9. Firmly place the foam strip on the back of the cable cover, next to the gathered
cables.
10. Place the front of the cable cover (F) over gathered cables and foam so it adheres.
Loading ...
Loading ...
Loading ...