Loading ...
Loading ...
Loading ...
8
3 Installation
3.1 Appropriate installation
location
In order to prepare the product for
use, refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and technician to have
any necessary arrangements carried
out.
B
WARNING:
Manufacturer shall not be
held liable for damages
that may arise from
procedures carried out by
unauthorized persons.
B
WARNING: Product
must not be plugged
in during installation.
Otherwise, there is the
risk of death or serious
injury!
A
WARNING: If the door
clearance of the room
where the product shall
be place is so tight to
prevent passing of the
product, remove the door
of the room and pass the
product through the door
by turning it to its side;
Alternatively, carefully
remove the product doors
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall, pay
attention to leave at least 5 cm
distance with the ceiling and side
walls.
• Do not install the product in places
where the temperature falls below
-5°C.
• Your product requires adequate
air circulation to function
efficiently. If the product will be
placed in an alcove, remember
to leave at least 5 cm clearance
between the product and the
ceiling, rear wall and the side
walls.
• If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is
present at its location (if
provided with the product). If
the component is not available,
or if it is lost or fallen, position
the product so that at least 5 cm
clearance shall be left between
the rear surface of the product
and the wall of the room.
The clearance at the rear is
important for efficient operation
of the product.
Loading ...
Loading ...
Loading ...