Loading ...
Loading ...
Loading ...
Supplement ProSear Models
27
Match Lighting:
If burners will not light after several attempts, the burners can be match lit. If you had already
attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate
prior to lighting with match.
Main IR burners:
Make sure all knobs are in the OFF position. Keep your face as far away from the grill as pos-
sible. With the Lid open, pass a lit, long stemmed match to the front center area of the IR burner
where the electrode igniter is positioned. Push and turn the corresponding control knob of the
burner to “Lite”. If the burner does not light in 4 seconds, turn the knob off and wait 5 minutes
before attempting again.
Rotisserie Burner:
Refer to main User Manual for instructions on match lighting the IR Rotisserie burner.
Burner Cleaning
After each use, it is important to operate the burners on “HI” with the grill lid open to burn away
any food particles or drippings. Operate the burners on “HI” for 5 minutes.
Some ash may accumulate on the burner surface over time. Ocassionly, you should brush, blow
or vacuum this debris from the surface of the burner. Only perform this operation when the burn-
ers are cool and do so carefully.
Every 3 to 6 months, inspect the burner venturi (inlet) to ensure there are no obstructions. If any
obstructions can be seen, then use a bottle brush to clean out the venturi area.
ProSear Burner Positioning
If you move an IR burner it is extremely important to re-position it correctly so that it is precisely
centered on the orifice and is sitting level before attempting to light the grill.
Positioning the burners:
Replace the burner by sliding the bracket at the front over the brass orifice and setting the rear
bracket of the burner in to the slots of the rear burner hanger. IT IS CRITICAL TO CENTER THE
BURNER ON THE ORIFICE AND FOR THE BURNER TO REST LEVEL AND NOT ROCK.
Rev. 04/2005
Loading ...
Loading ...
Loading ...