Loading ...
Loading ...
Loading ...
49-2000791 Rev. 1 23
Oven Door
Oven Door Removal
NOTE: Door removal is not a requirement for installation
of the product but is an added convenience.
To remove the door:
1. Open the oven door as far as it will go.
2. Push both hinge locks down toward the door frame to
the unlocked position. This may require a flat-blade
screwdriver. DO NOT LIFT THE DOOR BY THE
HANDLE!
3. Place hands on both sides of the door and close the
oven door to the removal position (approximately
1”–2” [2.5 cm–5.1 cm] from the closed position).
4. Lift the door up and out until
the hinge arms clear the
slots. NOTE: The oven door
is very heavy. Be sure you
have a firm grip before
lifting the oven door off the
KLQJHV8VHFDXWLRQRQFHWKHGRRULVUHPRYHG'R
not lay the door on its handle. This could cause dents
or scratches.
Replacing the Oven Door
NOTE: The oven door is heavy. You may
need help lifting the door high enough to
slide it into the hinge slots. Do not lift the
door by the handle.
1. Lift the oven door by grasping each
side.
2. With the door at the same angle as
the removal position
(approximately 1”–2” [2.5
cm–5.1 cm] from the closed
position), seat the notch
of the hinge arm into the
bottom edge of the hinge
slot. The notch of the hinge
arm must be fully seated
into the bottom of the slot.
3. Fully open the door. If
the door will not fully
open, the indentation is
not seated correctly in
the bottom edge of the
slot.
4. Push the hinge locks up
against the front frame
of the oven cavity, to the locked position.
5. Close the oven door.
Hinge in
Locked
Position
1RWFKRI+LQJH
Securely Fitted
Into Bottom of
Hinge Slot
Bottom
Edge of
Slot
Hinge
Arm
+LQJH1RWFK
Hinge
Slot
Hinge
Arm
+LQJH8QORFNHG
Position
Hinge Clears Slot
The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle.
Before removing the door, disconnect the camera harness by unhooking the connector that is snapped
into the bottom of the door.
CARE AND CLEANING: Oven Door
Loading ...
Loading ...
Loading ...