Loading ...
Loading ...
Loading ...
2. Let the engine run until it stops.
3. Disconnect the spark plug cable.
(Fig. 30 )
4. Tilt the product to its left side, with the air filter (A) up
and the muffler down.(Fig. 31 )
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 8
.
Maintenance Daily Weekly Monthly
Do a general inspection X
Examine the oil level X
Clean the product X
Examine the cutting equipment X
Examine the cutting cover* X
Examine the engine brake handle* X
Examine the air filter X
Examine the muffler* X
Examine the spark plug X
Clean the air filter X
Change the air filter X
Examine the fuel system X
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
To clean the product
WARNING: Obey the instructions in
Before
you do maintenance work on page 10
before
you clean below the product.
CAUTION: Do not use detergent, gasoline
or solvents to clean the product. That can
cause damage to plastic parts.
• Do not use a high pressure washer to clean the
product.
•
If you use water to clean the product, do not flush
water directly on the engine.
•
Use a brush to remove leaves, grass and dirt.
• Make sure that the cold air intakes are not blocked.
• Remove the fan (see
To replace the blade and fan
on page 12
) and clean it with a brush.
• Clean the surface of the product with a dry cloth.
• Clean below the product with a scraper to remove
the buildup of grass and waste.
To examine the cutting equipment
WARNING: To prevent accidental start
remove the ignition cable from the spark
plug.
WARNING: Use protective gloves when you
do maintenance on the cutting equipment.
The blade is very sharp and cuts can easily
occur.
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes the
product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.
504 - 003 - 26.01.2018 11
Loading ...
Loading ...
Loading ...