Loading ...
Loading ...
Loading ...
English - 14
installation & maintenance
The User’s Manual is for common use.
Make use of the User’s Manual depending upon your washing machine model.
ENVIRONMENT
Leave some space
Maintain at least 10 cm between the washer and the wall.
Place the washer on a sturdy fl at surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may
destroy the electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic an electrical components are affected by direct heat, never place the washer near furnaces,
boilers, etc. Do not place under direct sunlight.
LEVELLING
• If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So,
make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
• Open the lid of the machine, pour water into the tub up
to the level just below the pulsator, and adjust the legs so
that the pulsator is positioned at the center of the water as
shown in the fi gure.
• Place the machine more than 10 cm away from the wall.
• Adjust the legs on feet for levelling.
CONNECTING THE WATER SUPPLY HOSE
1. Remove the adaptor from the water supply hose.
2. First, using a “+” type screw driver, loosen the four screws
on the adaptor. Next, take the adaptor and turn part (b)
following the arrow for gap about 5 mm between them.
3. Connect adaptor to the water tap by tightening the screws
fi rmly. Then, turn part (b) following the arrow and put (a)
and (b) together.
a
b
Water
LOOSEN
LOCK
5 mm
WA4000HS_DC68-03414B-05_EN.indd Sec10:14WA4000HS_DC68-03414B-05_EN.indd Sec10:14 2020-03-03 3:25:332020-03-03 3:25:33
Loading ...
Loading ...
Loading ...