Loading ...
Loading ...
Loading ...
A
Adjust feet so that the product
will be balanced in the location
it will be used.Balance the
machine by adjusting the feet.
Check for any play by pressing
the product from upper
diagonal edges.
Otherwise, the product may
move from its place and cause
crushing, noise and vibration
problems.
Do not use any tools to loosen
the lock nuts. Otherwise, the
lock nuts may get damaged.
• Loosen the lock nuts on the feet
by hand.
• Adjust the feet until the product
stands level and balanced.
• Tighten all lock nuts again by
hand.
• When you turn the knob (visible
in the circle) in the direction of
the arrow, the machine will be
elevated by 0.3 mm. When you
turn it in the opposite direction
of the arrow, the machine will be
lowered by 0.3 mm.
• Do not adjust the rear feet by
using chargeable devices. Use a
screwdriver instead.
Connect the product to a grounded
outlet protected by a 13 A fuse. Our
company shall not be liable for any
damages that will arise when the
product is used without grounding in
accordance with the local regulations.
• Connection must comply with
national regulations.
• The wiring for the electrical
outlet circuit must be sufficient
to meet the appliance
requirements. Use of a Groud
Fault Circuit Interrupter (GFCI) is
recommended.
• Power cable plug must be within
easy reach after installation.
• If the current value of the fuse
or breaker in the house is less
than 13 Amps, have a qualified
electrician install a 13 Amp fuse.
• The voltage specified in the
"Technical specifications" section
must be equal to your mains
voltage.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
16
Loading ...
Loading ...
Loading ...