Loading ...
Loading ...
Loading ...
Care & use/ FIre PIT InsTallaTIon
|
9
lIGHTInG InSTRUCTIOnS
STEP1: Make sure the gas valve on the LP Tank is in the open position
STEP2: Start the spark igniter by pressing the ignition button. The starter will stay on until the button is pressed again.
STEP3: Using the Gas Valve Key, open the gas control valve through
the opening in the control panel. Turn the key to the left (counter-
clockwise) until it is full open. The burner should light immediately. If
the burner does not light in 4 seconds, turn the gas valve OFF, push
the ignition button to turn off the igniter, Wait 5-minutes for any gas
to dissipate, then try again steps 2 and 3 again. If the burner fails to
light contact Sedona Customer Care.
STEP4: If the burner has lit, push in the ignition button to shut of the
ignition module.
STEP5: Use the gas valve key to adjust the flame to a comfortable
level. DO NOT LEAVE A LIT FIRE-PIT UNATTENDED!
Shutting Down the Fire Pit
STEP1: Using the Gas Valve Key Turn off the gas to the burner by turning the Key to the right (clockwise) until the valve
fully closed
STEP2: Shut OFF the LP tank gas valve
Converting to a reFreSHMent BoWL
You new Sedona Fire Pit is easily converted into a icy beverage holder for those warm days when a fire pit Is not needed.
STEP1: Shut off gas from the LP cylinder
STEP2: Disconnect the ignition wire at the Molex Connector
STEP3: Lift out the burner pan using the convenient handle
STEP4: Insert the Ice pan into the cutout opening
STEP5: Fill with ice and your favorite beverages and enjoy.
Loading ...
Loading ...