Loading ...
Loading ...
Loading ...
Page 18 of 22
WATER-DRAINAGE
This model is an advanced self-evaporative air conditioner, which reduces the need to
empty the water tank in cooling mode. If the unit is vented correctly most of the water is
reused to cool the condenser coils and any excess is evaporated. As such for cooling mode,
to ensure the unit runs at maximum efficiency, we would advise for continuous drainage not
to be used.
MANUAL DRAINAGE:
• When the internal water tank is full the unit will stop working, and the unit will display
“E2” or “E4”
• Shut off the unit and unplug. Try not to move the model abruptly as this may cause
water to spill out from the internal water tank.
• Place a tray under the water plug.
• Remove the water plug and attach a drain pipe running to the water container - water
will drain from the internal container.
• Put the water plug back securely.
CONTINUOUS DRAINAGE:
• Remove the water plug
• Connect a water pipe to the water outlet.
• You can plumb this pipe into your current plumbing system, lead it outside or use a
water pump.
NOTE:
• Please make sure that the rubber bung or a drain pipe is in place when the unit is
running.
• When operating the heating function, a drain pipe should be installed in order to
improve the heating effect.
• When operating the dehumidifying function the unit must be used with a drain hose.
• When the water tank is full,”E2” or "E4" will be displayed on the display panel. Please
remove the rubber bung from the drain port and remove the water collected. After the
drainage is completed, please restart the unit and then the unit can operate normally.
Loading ...
Loading ...
Loading ...