Loading ...
Loading ...
Extend latch bolt (Regular deadbolt models)
7
Adjust the backset of the latch (if needed)
8
Hold the latch in front of the door hole, with
the latch face ush against the door edge.
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 9.
If the D-shaped hole is NOT centered, adjust
latch. See “Latch Adjustment” (step 8C).
Latch Adjustment (only if needed)
not centered
centered
A
B
C
180°
Rotate the front of the
latch to extend it.
Prepare latch (if not pre-assembled)
9
interior
Install deadbolt interior.
A
C
(Ring adapter available
with some models)
Insert interior
torque blade
into exterior
torque blade.
exterior
Rotate torque
blade to align
with D-shaped
hole.
Install deadbolt exterior.
Not available with
all models
Remove interior cylinder.
Pull paper tab to
remove cover plate.
Reinstall cylinder.
Do not reinstall
cover plate.
cover plate
Interior cylinder
has holes.
or
Remove cover plate from interior cylinder (For double cylinders only).
B
Door edge NOT
chiseled
Door edge chiseled
Install plate.
Ensure plate snaps into place.
Ensure collar snaps into place.
Install collar.
or
2 tabs
2 tabs
Pull plate to test for tight t.
Pull plate to test for tight t.
Door edge NOT
chiseled
Door edge chiseled
wood block
Retract latch bolt.
Extend latch bolt.
2x
Install front plate.
Install
latch.
Install
latch.
or
“UP” is on top
“UP” is on top
Install latch (Regular deadbolt models)
10
11
Install deadbolt (Regular deadbolt models)
The cylinder with holes
should be installed on the
interior side of the door.
Make sure hole in door
frame is drilled a minimum
of 1in (25mm) deep.
Install strike on door frame
12
or
Longer screws install
closest to jamb.
A
B
or
Loading ...
Loading ...