Loading ...
Loading ...
Loading ...
4
INSTALLATION OF MOUNTING ASSEMBLY (CONTINUED)
c. Be sure the sink is clean. Install a bead of plumbers putty to the sink
flange (1). From top of the sink, push the sink flange down against
the sink opening to make a good seal (2). DO NOT MOVE OR
ROTATE the sink flange once it has been seated or the seal may be
broken.
d. Place a heavy object, such as the disposer (use a towel
to prevent sink scratching) on top of the Sink Flange to
hold it down.
e. Take the remaining portion of the mount assembly, that was put aside.
From under the sink insert the Fiber Gasket (3), then the Support Flange (4),
and then the Upper Mount Ring (5).
f. Hold the three parts in place while attaching the Retainer Ring (6) by pulling
it apart and sliding it onto the sink flange (7) until it snaps into the groove of
the sink flange (7).
g. Tighten the three Mount Screws evenly and firmly against the Support
Flange (8). Do not over tighten.
h. Trim off any excess plumber’s putty.
i. Attach disposer onto the Upper Mount Ring by aligning the three mount tabs
on the Lower Mount Ring with the slide-up Ramps on the Upper Mount Ring
and rotating counter clockwise. See Below.
1
2
3
4
5
7
6
8
Removable Splash Guard
Sink Flange
Plumber’s Putty (not included)
Sink
Upper Mount Ring
Mounting Screw
Retainer Ring
Cushion Ring
Lower Mount Ring
Rubber Gasket
Reset Button
Fiber Gasket
Support Flange
The lower mounting ring (which is part of
the disposer) has 3 tabs that grab the
mounting ring ramp.
(A) points to the Upper Mount Ring.
(B) is the tab that slides up onto the
“Ramp”.
(C) is the "Ear" that is used to help rotate
the Lower Mount Ring.
Use a screwdriver for leverage if needed.
A
B
C
D
Elbow Flange & Screw Set (2)
Elbow
Spring Clamp Ring
Elbow
Groove
Lift and turn the Lower Mount
Ring counter clockwise until all
three mount tabs lock over the
Ridges (F) on the slide-up Ramps
(D) of the Upper Mount Ring.
As the Lower Mount Ring is turned counter clockwise
each tab slides up onto the Upper Mount Ring Ramp (E)
and locks in position over the Ridges (F).
Use a screwdriver or hammer for leverage if needed.
If a disposer needs to be removed, tapping on the Ear
clockwise with a hammer will easily loosen the Lower
Mount Ring.
E
F
OR
WDJ-XXX
FWDJ-XXX
Loading ...
Loading ...
Loading ...