Loading ...
Loading ...
Loading ...
9
EXTRA RINSE:
When he EXTRA RINSE option is selected, washing-rinsing steps will be added into the selected program so
you can ensure that your dishes will be extra clean and glossier.
DELAY:
To delay the start of a selected cycle, press the Delay Start button until the desired delay time shows in the
LED display. You can delay the start time for 1 to 19 hours. To cancel the delay start option before the set
delay period is over, simply press and hold the DELAY button for approximately 3 seconds.
1) Select the desired Pre-Programmed Wash Program as directed above.
2) Before pressing the “START/PAUSE” BUTTON, press the “DELAY” button.
3) Set the “delay” time by pressing the “DELAY” timer button. Time will increase in increments of 1 hour with
each press of the button.
4) Once the “DELAY” button is pressed the display will alternately show 1H and will also show the program
number selected within 2 seconds the delay time.
5) Close the door of your appliance and press the “START / PAUSE” button.
Note: If you open and close the door of the machine during the delay timer mode, or there has been a
loss of electric power, the machine will continue in delay timer mode until the timer has run out and will
start the wash program as selected.
CANCELLING A DELAY TIME SET:
To cancel the delay timer function once set.
1) Press and hold the “DELAY” button for approximately 3 seconds.
2) After 3 seconds, the display will show “0h” confirming the cancellation of the delay timer program.
3) You can now select a new wash program as previously directed above.
Note: You cannot set a delay time mode once a wash program has begun.
END OF CYCLE
At the end of the wash cycle, “0” will be shown in the display.
Open the door of the machine, press and hold the “START/PAUSE” button for approximately 3 seconds to turn
the unit off.
OVERFLOW PROTECTIONS
Our Avanti dishwasher has an overfill protection device which could automatically shut off the inlet valve and start
the drain pump if the water overflows. In the event of an overflow, the system display will flash “F1” and will
attempt to drain the water. If the overflow stops and the system drains the water the “F1” will disappear.
If the system cannot stop the overflow condition, turn off the main water supply before calling a servicer. If there
is water in the base pan because of an overfill or small leak, the water should be removed using a a sponge
before restarting the dishwasher.
WATER CUT OFF - WARNING
If during a wash cycle the water main is cut-off or turned off and the machine cannot take in water the display
will flash “FF”. As long as the condition or lack of water remains the display will continue to flash “FF”, once
the water is returned to the unit, it will return to normal working mode.
LOSS OF ELECTRIC POWER - WARNING
If during a wash cyle the electricity is lost or turned off or the door of the machine has been opened, the
machine cannot operate normally, the machine will return to normal working mode after 8 seconds once the
power has returned and if the internal temperature of the unit is above 113ºF.
DETERGENT DISPENSER
The dispenser must be refilled before the start of each wash cycle following the instructions provided in the
Loading ...
Loading ...
Loading ...