Bertazzoni P784ICHNE 78cm Modern Series Induction Cooktop

User Manual - Page 83

For P784ICHNE.

PDF File Manual, 148 pages, Read Online | Download pdf file

P784ICHNE photo
Loading ...
Loading ...
Loading ...
FUNZIONAMENTO
I
83
OPERATION GB
centrale 78 b2O
This device allows you to choose the operating mode (suction or ltration), depending on the
installation.
Upon rst start-up, the display shows which operating mode is enabled.
Filtration: the display shows the letters C and the lter reset button ashes quickly.
Suction: the display indicates the letter C and the lter reset button is o.
During this phase you can change the operating modes by pressing the key F
A beep conrms the program change.
Once the set time elapses, the program will exit this operating mode and goes to standby mode or
by pressing the on/o button of the motor
To access the operating mode selection again, turn o power to the appliance and then power it
again.
Note: in suction mode, when the device is turned o, suction still operates for 20 minutes at a
minimum speed, to allow evaporating any possible condensation that has formed during the
cooking phases.
B:Motor on/o key: when touched, this key enables the motors; if pressed, it shuts down the
motor. By operating the keys “+” and “-” the user can modify the suction speed (power).
C:Suction speed (power) decrease key: when touched, this key decreases the suction speed of
the hood.
D:Suction speed (power) increase key: when touched, this key increases the suction speed of
the hood.
F:Filter reset key: when touched, this key will reset the warnings on anti-grease metal lter (1)
saturation and replacement of carbon lter (2).
(1) After 30 hours of hood operation, the symbol F, alternating with the symbol G, will ash
indicating the need to clean the anti-grease metal lters; this alarm prevents the operation of the
suction system until it is reset, to allow the condensate tray to empty (operation to be performed
as needed, but however each time you reset the lters).
(2) Active only in ltration mode: After 120 hours of operation of the hood, the symbol F,
alternating with the symbol C, will ash indicating the need to clean/replace the activated carbon
lters; the carbon lters can be washed in the dishwasher once, and then they must be replaced.
In suction mode, the alarm of carbon lters is disabled.
A
B C
Display
D
E F
Loading ...
Loading ...
Loading ...