Loading ...
Loading ...
Loading ...
High-pressure washer does not
have sufficient pressure
1. Check the water supply for ade-
quate delivery rate.
2. Pull out the filter from the water con-
nection using flat-nose pliers, an
d
cle
an the filter under the running wa-
ter.
3. High-pressure washer ventilation
:
a
Disconnect the high-pressure
hose.
b Switch the high-pressure washer
on, and operate the high-pressure
washer (max. 2 minutes) until the
water exits the high-pressure con-
nection without bubbles.
c Switch the high-pressure washer
off.
d Reconnect the high-pressure
hose to the high-pressure washer.
Strong pressure fluctuations
1. Check the water level in the water
ta
nk.
2. Clean the high-pressure nozzle:
a Remove the dirt / dust from t
he
no
zzle bore using a needle.
b Apply water to the front of the noz-
zle bore to rinse it through.
High-pressure washer is leaking
Slight leakage from the high-pres-
sure washer pump is normal. If
the
leakag
e increases, please con
tact
th
e next authorised customer ser-
vice site.
Battery in not charging.
The temperature of the motor or bat-
tery is hot. Wait for it to cool down.
Accessories and spare parts
Only use original accessories and orig-
inal spare parts. They ensure that the
high-pressure washer will run fault-free
and safely.
Information on accessories and spare
parts can be found at www.kaerch-
er.com.
High-pressure washer is not
running
1. Pull on the lever of the trigger gun to
switch the high-pressure washer on.
2. Switch the high-pressure washer off
via the “ON / OFF” switch. Wait a
few seconds, and switch the high-
pressure washer on again.
3. Check the charging status of the
battery.
4. Check whether the tank valve is
connected to the male tank connec-
tor.
Fill the tank with a half tank of water
or press the bottom of the tank to
lower the tank.
1
Tank valve
2
Male tank connector
5. If the temperature of the motor or
battery is hot, please wait for it to
cool down.
1
2
English 19
Loading ...
Loading ...
Loading ...