Loading ...
Loading ...
Loading ...
© 2016 DJI. All Rights Reserved.
7
1. Solder the ESC’s black and red power cables to the pads on the PDB
as shown.
2. Connect the signal cable to your ight controller. The signal cable’s
white wire transmits the control signal; the red wire transmits the data
signal; the black wire is for ground.
3. Connect the motor to the ESC.
Be sure to solder the cables to the pads according to
the specications of your PDB.
The PDB in the gure uses its outer pads for the black
cables, and the inner pads for the red cables. Cut the
cables to length. The cables should not be so long as
to bunch up near the solder point.
Signal Cable (To ight controller)
ESC
Power Cables
Motor
PDB
Ensure that there are no open circuits or short circuits when
soldering the ESC cables.
It is recommended that you solder a power connector on the
PDB for the battery.
Loading ...
Loading ...
Loading ...