Loading ...
Loading ...
Loading ...
Troubleshooting
If a problem should arise, first check the following.
1. Are the connections correct?
2.
Is the unit being operated as described in the owner’s manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
n
Power does not turn on / Power is turned off
Symptom Cause / Solution Page
Power is not turned on.
0
Check whether the power plug is correctly inserted into the power outlet.
10
0
This unit is in standby mode. Press the X CD button on the remote control.
11
Power automatically turns off.
0
The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode when the unit is not operated for
approximately 30 minutes. To disable Auto Standby mode, set “Auto Standby” on the menu to “Off”.
24
The power turns off and the power
indicator blinks in red when a USB
memory device is connected.
0
The connected USB memory device is not supported. Please use a USB memory device with an operating current that is less than
1A.
－
0
The device requires more power than can be supplied by this unit via USB. Press X
on this unit to turn the power off, remove the
USB memory device and then turn the power on again.
－
n
Operations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be performed
through the remote control unit.
0
Batteries are worn out. Replace with new batteries.
2
0
Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an angle of within 30°. 2
0
Remove any obstacle between this unit and the remote control unit. －
0
Insert the batteries in the proper direction, checking the q and w marks.
2
0
The unit’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the unit to
a place in which the remote control sensor will not be exposed to strong light.
－
0
When using a 3D video device, the remote control unit of this unit may not function due to effects of infrared communications
between units (such as TV and glasses for 3D viewing). In this case, adjust the direction of units with the 3D communications
function and their distance to ensure they do not affect operations from the remote control unit of this unit.
－
0
Press the REMOTE MODE CD button to switch the remote control operating mode to “CD”.
7
0
When using this unit independently, set the switch to “INTERNAL”. 10
ENGLISH
27
PrintingColor:Black
Loading ...
Loading ...
Loading ...