Loading ...
Loading ...
Loading ...
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal, it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink system.
To erase the channels, place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up 20 seconds or until the red
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
Programming A Rolling Code
For programming garage door openers that were manufac-
tured after 1995:
These garage door openers can be identified by the “LEARN”
or “TRAIN” button located where the hanging antenna is
attached to the garage door opener. It is NOT the button that
is normally used to open and close the door. The name and
color of the button may vary by manufacturer.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
76 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...