Loading ...
Loading ...
Loading ...
17TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE AND REMEDY REMEDY
The residual heat
indicator does not
comes on.
The cooking zone is not hot because it
operated only for a short time.
If the cooking zone should be hot, speak to
the service centre.
The Automatic Heat
Up function does
not operate.
• There is still residual heat on the
cooking zone.
• The highest heat setting is set.
• Let the cooking zone become
sufficiently cool.
• The highest heat setting has the same
power as the Automatic Heat Up function.
The heat setting
changes between
two levels.
The Power management is activated. See the section Power management.
The sensor fields
become hot.
The cookware is too large or you out it too
near to the controls.
Put large cookware on the rear cooking zones
if it is necessary.
comes on
The Automatic Switch Off operates. Deactivate the appliance and activate it again.
comes on
• No cookware on the cooking zone.
• Not correct cookware.
• The diameter of the bottom of the
cookware is too small for the cooking zone.
• Put cookware on the cooking zone.
• Use the correct cookware.
• Move cookware to a smaller cooking zone.
and a number
comes on.
There is an error in the appliance. Disconnect the appliance from the electrical
supply for some time. Disconnect the fuse
from the electrical system of the house.
Connect again. If comes on again, speak
to the service centre.
comes on
There is an error in the appliance, because
either the cookware boils dry or you’ve used
incorrect cookware. Overheating protection
for cooking zone operates. The automatic
switch-off operates.
Deactivate the appliance. Remove the
hot cookware. After approximately 30
seconds, activate the cooking zone again.
If the cookware was the problem, the error
message goes out of the display, but the
residual heat indicator can stay. Let the
cookware become sufficiently cool and refer
to “Cookware for the induction cooking zone”
to see if your cookware is compatible with
the appliance.
Loading ...
Loading ...
Loading ...