Loading ...
Loading ...
Loading ...
Loading the salt into the softener
Always use salt intended for use with dishwasher.
If your model has no water softener, you may skip this section
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will
form on the dishes and utensils.
The appliance is equipped with a special softener that uses salts specifically designed to eliminate lime and
minerals from the water.
The salt container is located beneath the lower basket and should be filled as follows:
CAUTION: Only use salt specifically designed for use in dishwashers! All other types of salt not
specifically designed for use in a dishwasher, especially table salt, will damage the water softener. In
case of damages caused by the use of unsuitable salt the manufacturer does not give any warranty
nor is liable for any caused damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split, remaining on the bottom
of the machine for any period of time, which may cause corrosion.
After the first wash cycle the control panel light expires.
Prior using for the first time
DW4000KM-00000A-00_EN (Basic)_160323.indd 18
1. Remove the lower basket and then
unscrew and remove the cap from the
salt container.
1
2
Prior Using for the First Time _21
03 PRIOR USING FOR THE FIRST TIME
water hardness adjusting scheme
1.
Water hardness adjusting scheme ( DW60M5030FS/DW60M5030FW/
DW60M5010FS/DW60M5010FW )
When dishwasher is in standby mode, press the program button and the start button for 5s
(at the same time), then with a buzzle sound, the LED will show the water hardness spec setting,
release the button.
2.
Each time pressing the Delay button, the setting value will add "1" with a buzzle sound.
The value can be set from H0 to H7 repeatedly.
After setting, press the start button, the chosen value will be saved and the dishwasher will operate
according to the setting.
For the indicator of the water hardness value setting, please refer to below table:
WATER HARDNESS
mmol/l Value setting
Indicator
°Clark Range
on on on
on Flash on
on Flash Flash
Flash on on
Flash on Flash
Flash Flash on
Flash Flash Flash
on on Flash
1.1~0 tfos8~0
1H
0H
4.1~2.1 tfos01~9
2H 8.1~5.1 muidem21~11
3H 1.2~9.1 muidem51~31
4H 9.2~2.2 muidem02~61
5H 7.3~0.3drah62~12
H6
7H 9.8~5.5drah26~93
Loading ...
Loading ...
Loading ...