Loading ...
Loading ...
Loading ...
15
EN
Connecting the Supply Hose
• Water supply pressure must be between 0.1
MPa and 0.8 MPa (100 ~ 800kPa).
• Do not overtighten the water supply hose.
• If the water supply pressure is more than 0.8
MPa, a decompression device should be
installed.
• Periodically check the condition of the hose
even after installation and replace the hose if
necessary.
• Contact the service centre if there is no rubber
seal fitted to the hose ends.
Checking the Rubber Seal on the
Supply Hose
Two rubber seals are supplied with the water
supply hoses. They are used for preventing
water leaks. Make sure the connection to taps
is sufficiently tight. Do not use mechanical
devices such as multi grips to tighten the inlet
hoses.
Hose connector
Rubber seal
Hose connector
Rubber seal
Connecting Hose to Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw an inlet hose of the Main washer to the
COLD water supply tap.
Loading ...
Loading ...
Loading ...