Loading ...
Loading ...
Loading ...
49-80549-4
19
5
SIZE AND CUT DUCT PIECE
• Measure from the bottom of the air deflector to the
top of the hood as shown. Reduce that dimension
by 1” to facilitate installation. The duct will cover
DQGRYHUODSWKHGHIOHFWRUDQGWKHH[KDXVWRXWOHWLQ
the hood.
• Remove the air deflector from the duct cover
bracket.
• Cut the duct piece to size and slip onto the bottom
of the deflector.
• Place the assembled deflector and duct over the
H[KDXVWRXWOHW
• Hold the assembly against the duct bracket.
• Drive 2 screws into each side of the bottom of the
deflector and into the bracket.
• Use duct tape to seal duct to the deflector and at
WKHH[KDXVWRXWOHW
Measure
length
Duct
length
Deflector
4
MOUNT THE HOOD
WARNING
2 people are required to lift and position
the hood onto the mounting screws.
• Lift the hood onto the mounting screws.
• If using a wall fastener, make sure the washer is in
front of the flange and not behind it. Check with a
level before tightening screws.
• Install lower screws to pull the hood tight against the
wall.
Tighten
screws
Install
screws
Bottom
screw
location
,167$//$7,21³5(&,5&8/$7,1*
Installation Instructions
Loading ...
Loading ...
Loading ...