Loading ...
Loading ...
Loading ...
10
Care and Cleaning
Bowl, stainless steel flat beater, wire
whip, and spiral dough hook may be
washed thoroughly with soap and hot
water and rinse completely before drying.
Do not store beaters on shaft.
NOTE: Always be sure to unplug stand
mixer before cleaning. Wipe stand mixer
with a soft, damp cloth. Do not use
household/commercial cleaners. Do not
immerse in water. Wipe off beater shaft
frequently, removing any residue that may
accumulate.
Beater to Bowl Clearance
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of
the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away
from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer.
2. Place bowl lift handle in down
position.
3. Attach flat beater.
4. Adjust so flat beater just clears
bottom surface of bowl when in
lifted position by turning screw (A)
counterclockwise to raise the bowl
and clockwise to lower the bowl.
Just a slight turn is all that is
required: the screw will not rotate
more than 1/4 turn (90 degrees)
in either direction. (The full range
of adjustment is 1/2 turn, or
180 degrees.)
5. Place bowl lift handle in up
position to check clearance.
6. Repeat steps 4 and 5 if necessary.
NOTE: When properly adjusted, the flat
beater will not strike on the bottom or
side of the bowl. If the flat beater or the
wire whip is so close that it strikes the
bottom of the bowl, coating may wear off
the beater or wires on whip may wear.
Lower Bowl
Raise Bowl
W10508890A.indd 10 10/12/2012 3:24:08 PM
Loading ...
Loading ...
Loading ...