Loading ...
Loading ...
Loading ...
−
−
−
−
−
−
CONTINUED
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turnthe systemon by pushing the
PWR/VOL knob. Adjust the volume
by turning the same knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button (AM orFM button). On the
FM band, ST will be displayed if the
stationisbroadcastinginstereo.
Stereo reproduction in AM is not
available.
If you do nothing, the system will
then scan for the next strong station
andplayitfor10seconds.Whenit
plays a station you want to listen to,
press the SCAN button again.
Each side of the bars
(1 6) canstore one stationonAM,
and two stations on FM.
Use the TUNE knob to
tune the radio to a desired frequency.
Turnthe knobright totune to a
higher frequency, or left to tune to a
lower frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the or side of the
SEEK bar, then release it.
The scan function samples
all stations with strong signalson the
selected band. To activate it, press
theSCAN button, then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 10 seconds. Repeat steps 1 through 3 to store a
total of six stations onAM and
twelve stations onFM.
Pick a preset number (1 6), and
hold it until you hear a beep.
Usethetune,seek,orscan
functionto tune the radioto a
desiredstation.
Select the desired band, AM or
FM. FM1 and FM2 let you store
twelve stations.
You can use any of five methods to
find radiostationsonthe selected
band: the
preset buttons, and .
1.
2.
3.
4.
Playing the Radio
To Play the Radio
To Select a Station
PRESET
TUNE
SEEK
SCAN
TUNE,SEEK,SCAN,
AUTO SELECT
Features
109
０５／０９／０９ １８：１２：０４ ３１ＳＮＣ６００ ０１１２
Main Menu
Table of Contents
Loading ...
Loading ...
Loading ...