Loading ...
Loading ...
Loading ...
Operating Instructions
54
Safety InstructionsInstallation InstructionsTroubleshooting Tips
Consumer Support
Troubleshooting Tips
Problem Possible Causes What To Do
Oven light does not work Light bulb is loose or defective. • Tighten or replace the bulb.
Plug on range is not completely • Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet. grounded outlet.
Oven will not self-clean The oven temperature is too • Allow the range to cool to room temperature and
high to set a self-clean operation. reset the controls.
Oven controls improperly set. • See the Using the self-cleaning oven section.
“Crackling” or This is the sound of the • This is normal.
“popping” sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning oven section.
clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked • Touch the CLEAR/OFF pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F—and a number or You have a function error code. • Touch the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven shelves are The nickel shelves (if so equipped) • Apply a small amount of vegetable oil to a paper
difficult to slide were cleaned in a self-clean cycle. towel and wipe the edges of the oven shelves with
The gray porcelain-coated shelves the paper towel. Do not spray with Pam
®
or other
(if so equipped) were improperly lubricant sprays.
cleaned.
“Probe” appears in This is reminding you to enter a • Enter a probe temperature.
the display (some models) probe temperature after plugging
in the probe.
Before You Call For Service…
Loading ...
Loading ...
Loading ...