Loading ...
Loading ...
Loading ...
Consumer SupportInstallation Instructions Troubleshooting TipsOperating InstructionsSafety Instructions
33
Burner Caps and Heads
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic
scouring pad to remove burned-on
food particles.
Burner heads
The slits in the burner heads of your
cooktop must be kept clean at all times.
Clogged or dirty burner ports or
electrodes will not allow the burner to
operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit
an electrode with anything hard or it
could be damaged.
You should clean the burner caps,
burner heads and burner bases routinely,
especially after bad spillovers, which
could clog the openings in the burner
heads. Lift off when cool.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20–30
minutes. For more stubborn stains,
use a toothbrush.
After cleaning
Before putting the burner caps and
heads back, shake out excess water and
then dry them thoroughly by setting in a
warm oven for 30 minutes.
NOTE: Do not use steel wool or scouring powders
to clean the burners or electrodes. This can damage
the burners and electrically short the electrodes.
Replacement
The top sides of the Right Front, Right
Rear and Left Front burner heads are
marked with the letters “RF,” “RR” and
“LF,” respectively, to aid reassembly.
NOTE: Before removing the burner caps
and heads, remember their size and location.
Replace them in the same location after
cleaning. The top sides of the Right Front,
Right Rear and Left Front burner heads are
marked with the letters “RF,” “RR” and “LF,”
respectively, to aid reassembly.
When replacing, make sure the locator pins in the
burner head are seated in the pin slots of the burner
base. Rotate the burner head around the burner base
until it is level and securely seated.
www.GEAppliances.com
Replace the burner heads on the bases
matching the letters. Replace the caps on
the heads. Make sure that the caps and
heads are replaced in the correct
location. There is one small, one
medium, one large and one extra large
head and cap.
Medium head
(not marked)
and cap
Front of range
Large head
and cap
Small head
and cap
Extra large
head and
cap
Locator pins
Pin slots
LF
RR
RF
Loading ...
Loading ...
Loading ...