Loading ...
Loading ...
Loading ...
E-6
Make sure to unplug the AC power cord before in-
stalling the sound bar or changing the position.
To mount the sound bar on the wall
Caution:
● Be very careful to prevent the sound bar [5.1 lbs.
(2.3 kg)] from falling when mounting on the wall.
● Before mounting, check the wall strength. (Do not put on
the veneer plaster or whitewashed wall. The sound bar
may fall.) If unsure, consult a qualied service techni-
cian.
● Mounting screws are not supplied. Use appropriate
ones.
● Check all wall mount angle screws for looseness.
● Select a good location. If not, accidents may occur or the
sound bar may get damaged.
● SHARP is not responsible for accidents resulting
from improper installation.
■ Driving screws
SHARP designed the sound bar so you may hang it on the
wall. Use proper screws (not supplied). See below for size
and type.
1/8” (3.2 mm)
3/8” (9 mm)
7/8” (Min. 22 mm)
3/16”
(5 mm)
■ Installing the sound bar
1 Fix the pattern paper to the wall in horizontal posi-
tion as below.
44 mm
509 mm
Wall surface
Pattern paper
(supplied)
21-5/8” (548 mm)
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
Wall surface
1-1/4” (32 mm)
3/8” (8-9 mm)
3 Fix a wall mount plug into the hole using a hammer,
until it is ush with the wall surface.
1-1/4” (32 mm)
3/8” (8-9 mm)
Wall sur
face
4 Fasten the screws to the wall as shown below. (Total
screw is 2 pieces)
Wall surface
Wall surface
Screw using
screwdriver
3/16” (4.5 mm - 5 mm)
Gap from wall
surface
5 Hang the sound bar onto the screws.
System preparation
Falling prevention
● Safety wires (not supplied) are useful to prevent the
sound bar from falling.
■ When mounting on the wall
SOUND BAR HOME THEATRE SYSTEM HT-SB35D
Safety wires
(not supplied)
Sound bar
Screw eye
(not supplied)
Wall
Loading ...
Loading ...
Loading ...