Loading ...
Loading ...
Loading ...
6
Unpacking and Examining Your Oven
Carefully remove oven from carton.
Remove:
1. all packing materials from inside the oven cavity; however, DO NOT RE-
MOVE THE WAVEGUIDE COVER, which is located on the ceiling in the oven
cavity. Check to see that there are Installation Instructions, Wall Template
and Top Template. Read enclosures and SAVE the Operation Manual.
2. the feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door, damaged
door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door.
If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER.
See Installation Instructions for more details.
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.
It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National
Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk
of electric shock by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
Check Installation Instructions for proper location for the power supply.
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a separate circuit serving only the oven be
provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded. DO NOT UNDER ANY CIRCUM-
STANCES CUT OR REMOVE THE GROUNDING PIN FROM THE PLUG.
Notes: 1. Ifyouhaveanyquestionsaboutthegroundingorelectricalinstructions,consultaqualiedelectrician
or service person.
2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury resulting
from failure to observe the correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave
oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check posi-
tion and signal of receiving antenna.
Charcoal Filter (RK-220). This is required when hood exhaust is recirculated. See Charcoal Filter on page 29.
Toorderlterreplacement,ifdealerdoesnotstockthisitem,itcanbeorderedbycalling1-800-237-4277.
Oven
cavity
Waveguide
cover
Hinges
Latches
Door seals and
sealing surfaces
UNPACKING INSTRUCTIONS
OPTIONAL ACCESSORY
GROUNDING INSTRUCTIONS
Loading ...
Loading ...
Loading ...