Loading ...
Loading ...
Loading ...
15
Installation instructions
Diagram 7 Diagram 8
Important!
All connections must be checked for leaks.
Ensure 6 mm (¼”) tubing is routed away from sharp objects,
sharp corners (beware of kinking tube as this will stop water
flow), clear of the refrigerator unit compartment and not in a
location where it can be squashed.
Ensure all push-fit connections are firmly pushed into place.
The tube should be pushed in 16mm (⁄”) before reaching
thestop.
If tubing is removed at any point, re-cut the end and re-insert.
Tubing must be fully inserted to avoid leaks.
To remove tube from connection points, turn off the isolating
tap, push in the collet and gently pull tubing at the same time
(refer to Diagram 6).
Open rear compartment installation
1
Mark a line of 16 mm (⁄”) on the end of the tube. Firmly push the marked water tube into the
water (solenoid) valve located on the right hand side of the rear compartment until the marked
line is not visible (refer to Diagram 7). Beware of hot pipes.
2
Pull gently on tubing to ensure it is locked (refer to Diagram8).
3
The completed installation should look like Diagram9. Turn isolating tap on and check that all
connections are dry and free of drips.
4
Coil water line tubing behind the refrigerator and push into position being careful not to kink or
squash the water line running into the water (solenoid) valve.
Diagram 6
Diagram 9
Completed installation
Loading ...
Loading ...
Loading ...