Documents: Go to download!
User Manual
- User Manual - (English, French, Spanish)
- 30 Day Satisfaction Guarantee - (English)
- Warranty - Personal & Healthcare - (English)
- 1. Parts List
- 2. Installation Diagram
- 3. Cabinet Diagram and Dimensions (For TK932S)
- 4. Left Duct Preparation
- 5. Microwave Oven Preparation
- 6. Lower Duct Installation
- 7. Cabinet Preparation
- 8. Trim Kit Preparation
- 9. Microwave Oven Installation
- 10. Trim Kit/Finishing Installation
Table of contents
User Manual Trim Kit
CAUTION Read and follow all instructions completely.
- This Trim Kit is designed for use only with the Panasonic Microwave Oven listed in the table below, for installation into a cabinet.
- The dimensions and ground clearance of the cabinet opening must be as indicated in Figure 1 on page 6 to 9.
- For safe use of your microwave oven, do not alter or modify any part of this kit or the microwave oven.
- The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical code, as well as any applicable local regulations. Refer also to the microwave operating instructions for other safety and electrical requirements.
- The microwave oven must be unplugged from the wall receptacle before attempting the installation of this kit.
- Save these instructions for local inspection and relocation of the microwave oven.
- Use caution so that the power cord is not pinched during installation.
- The diagrams in these instructions may vary from the actual unit and is only for reference.
1. Parts List
Tools Needed: Measuring tape, pencil, Phillips screwdriver, Ø 2 ( 5 /64") mm drill
Parts Supplied
2. Installation Diagram
Trim Kit Dimensions |
| |||
| TK932S | TK922S | TK732S | TK722S |
Width | 30" (760 mm) | 27" (684 mm) | 30" (760 mm) | 27" (684 mm) |
Height | 18 V (472 mm) | 18 %;" (472 mm) | 16 1/2" (419 mm) | 16 'A" (419 mm) |
Depth (Thickness) | %" (20 mm) | %" (20 mm) | %" (20 mm) | %" (20 mm) |
3. Cabinet Diagram and Dimensions (For TK932S)
4. Left Duct Preparation
Note: All folding must be done at a 90° angle. Otherwise, it won’t fit well.
5. Microwave Oven Preparation
Align the screw hole and tighten the screw.
Put a piece of the tape on the top of oven and put a piece of the tape on left of oven and left duct.
6. Lower Duct Installation
1. Aligning the base bracket assembly
Position Base Bracket Assembly on cabinet shelf. The front end of Base Bracket Assembly should align flush with the front edge of the shelf.
2. Attaching the base bracket assembly
7. Cabinet Preparation
- Bracket assembly
- Attaching the bracket
8. Trim Kit Preparation
Trim Frame
1. Inserting strikes
9. Microwave Oven Installation
Complete the assembly
1. Oven placement
10. Trim Kit/Finishing Installation
Complete the assembly
1. Trim frame installation
Note: Place the trim frame with the extended lip at the bottom
See other models: HC-VX870K DMW-TC20 DC-TS7K KX-TGM420 RB-M500B