Loading ...
Loading ...
Loading ...
en-us
7
Connecting the appliance
After installing the appliance, wait at least 8 hours until
the appliance is switched on. During transportation
the oil in the compressor may have flowed into
the refrigeration system.
, CAUTION:
Always connect the water before the power.
Before switching on the appliance for the first time, clean
the interior of the appliance (see chapter Cleaning
the appliance).
Water connection
The water may be connected only by a competent
plumber according to the local regulations of
the appropriate water supply company.
, WARNING:
Connect the appliance to a drinking water line
only!
■ Minimum pressure: 29 psi (2 bar)
■ Maximum pressure: 116 psi (8 bar)
■ Pressure over 116 psi (8 bar): install a pressure
limiter between drinking water connection and hose
set
A cold water connection is necessary for operating the
automatic ice maker.
Install a separate shut-off valve in the cold water supply
line.
The shut-off valve should not be located behind the
appliance. It is recommended that you mount the shut-off
valve directly next to the appliance or at another place
which is easily accessible.
Electrical connection
, WARNING:
Risk of electric shock!
Connect the appliance to a grounded, 3-phase
outlet only. Never remove the ground phase. Do
not use any adapters.Do not use any extension
leads.
, WARNING:
Risk of electric shock!
Incorrect connection of the appliance may result
in death, fire or electric shock. Improper
connection of the protective conductor may result
in electric shock. If you are in doubt as to whether
the appliance has been properly grounded, have it
tested by a qualified electrician or Customer
Service technician.
, WARNING:
Risk of electric shock!
If the length of the power cord is inadequate,
never use multiple outlets or extension leads.
Instead, please contact Customer Service for
alternatives.
This appliance must be connected to a permanently
installed outlet.
The outlet must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I. Connect
it to a correctly installed outlet. Correct means: with a
protective conductor, 110 V – 120 V/60 Hz alternating
current. The outlet must be protected by a 10 A – 16 A
fuse.
The appliance comes with a UL registered 3-wire power
cord. The appliance requires a 3-pole outlet.
Please observe the following table with regard to this:
Check on the rating plate whether the indicated voltage
and current type match the values of your power supply.
The position of the rating plate can be found in the
chapter entitled Customer Service.
, WARNING:
Never connect the appliance to electronic energy
saver plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are
used for photovoltaic systems which are
connected directly to the national grid. Sine-
controlled inverters must be used for isolated
applications (e.g. on ships or in mountain lodges)
which are not connected directly to the national
grid.
Appliance Maximum simultaneous
load
Fridge-freezer 6 A
Loading ...
Loading ...
Loading ...