Loading ...
Loading ...
Loading ...
7
Installation
REMOVE PACKAGING MATERIALS
IMPORTANT: Do not remove any permanent instruction labels or the data label on your tool box refrigerator
REMOVE TAPE AND GLUE FROM YOUR TOOL BOX REFRIGERATOR BEFORE USING
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be
easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with
warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue
inside the refrigerator compartment. These products can damage the inside surface.
CLEANING BEFORE USE
After you remove all of the packaging materials, clean the inside of your tool box refrigerator before using it.
INSTALLATION CLEARANCES
Your tool box refrigerator should be conveniently located for day-to-day use in a dry, well-ventilated room. Do not
install the tool box refrigerator where the temperature will go below 50°F or above 90°F, because it will not main-
tain proper temperatures. Be sure to install your tool box refrigerator on a floor strong enough to support it when it
is fully loaded.
FREESTANDING INSTALLATION
A freestanding installation will allow you to install the tool box refrigerator in any place you desire provided that
the required clearance space around the appliance is respected. In every setting, there must be adequate ventila-
tion and access for service. Never install or operate the unit in an enclosed area, such as a closed cabinet.
Before connecting the tool box refrigerator to the power source, let it stand upright for approximately 4 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
The normal operation of the tool box refrigerator depends on heat radiation from the condenser. Allow at least
6 inches of space between the back and sides of the appliance, which allows the proper air circulation to cool
the compressor and condenser. The installation should allow the tool box refrigerator to be pulled forward for
servicing if necessary.
This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water spray or drips. Do
NOT use in an outdoor setting.
The tool box refrigerator should not be located next to ovens, grills or other high heat resources.
Too much humidity in the air will cause frost to form quickly on the evaporator requiring more frequent de-
frosting of the tool box refrigerator.
Avoid locating the appliance in area that may be exposed to excessive moisture.
The tool box refrigerator must be installed with all electrical requirements followed.
The unit should be located on a hard and level surface that can support the unit when it is full. It is important
for the tool box refrigerator to be level in order to work properly.
Excessive Weight Hazard
Two or more people should move and install tool box refrigerator. Failure to do so can result in back or other
injury.
Loading ...
Loading ...
Loading ...