Loading ...
Loading ...
Loading ...
Care and Cleaning
Advantium Oven
35
Replacing the
surface light
1. To replace the surface light, first
disconnect the power at the main fuse
or circuit breaker panel or unplug the
oven.
2. Remove the screw from the side of the
light compartment cover and lower the
cover until it stops.
3. Be sure the bulb to be replaced is cool
before removing. Gently pull the bulb
from the receptacle.
Replace with a 130 volt, 50-watt
halogen bulb. Order WB08X10051
from your GE Appliances supplier.
4. Raise the light cover and replace the
screw. Connect electrical power to the
oven.
1. The metal filters trap grease released
by foods on the cooktop. They also
prevent flames from foods on the
cooktop from damaging the inside of
the oven.
2. For this reason, the filters must always
be in place when the hood is used.
The vent filters should be cleaned
once a month, or as needed.
3. To remove, slide them to the rear
using the tabs. Pull down and out.
4. To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don’t use ammonia or
ammonia products because they will
darken the metal. Light brushing can
be used to remove embedded dirt.
5. Rinse, shake and let dry before
replacing.
6. To replace, slide the filters into the
frame slots on the back of each
opening. Press up and to the front to
lock into place.
Removing
and cleaning
the filters
Replacing the
oven cavity
lamp
1. Disconnect power at the main fuse or
circuit breaker panel.
2. Remove the top grill by removing the
two screws that hold it in place.
3. Remove charcoal filter if present.
Slide the filter toward the left and pull
toward the front to remove. NOTE:
Charcoal filter is an optional kit, you
may not have one.
4. Remove the screw holding the lamp
shield in place.
5. Pull the lamp shield out. Pull the
light bulb out and replace with the
120V-130V, 20-watt halogen bulb.
Order WB25X10019 from your GE
Appliances supplier.
6. Return the lamp and lamp shield to
original position and replace screw and
charcoal filter.
7. Replace the grill and 2 screws.
Reconnect power to the oven
Remove screw
Loading ...
Loading ...
Loading ...