Loading ...
Loading ...
Loading ...
THROTTLE BODY/IDLE RPM
Idle RPM is preset by the manufacturer. If the engine idle speed is not
satisfactory, please see your POLARIS dealer or other qualified service facility
for adjustment.
THROTTLE CABLE FREEPLAY
1. Remove the four cover screws from the right handlebar control and remove
the cover.
2. With the handlebars straight ahead, place very light pressure on the throttle
lever. A gap of 2-3 mm should be visible between the throttle arm stop pin
and the throttle arm.
If adjustment is needed:
1. Locate the throttle cable adjuster. Squeeze the end of the rubber boot and
slide it back far enough to expose the inline cable adjuster locknut.
2. Loosen the adjuster locknut.
3. Rotate the boot to turnt he adjuster until 2-3 mm of freeplay is achieved
between the stop pin and the throttle arm. While adjusting freeplay, flip the
throttle lever back and forth repeatedly.
4. Place the transmission in PARK. Lock the parking brake.
5. Start the engine and allow the idle to stabilize. If necessary, tap the throttle
lever to ensure the idle speed settles.
6. If idle speed remains above or below the recommended setting (see
specification pages), verify the correct gap. If gap is correct and idle speed is
still not satisfactory, please see your POLARIS dealer or other qualified
service facility for service.
7. With the engine running, turn the handlebars fully to the left and right. Tap the
throttle lever at each turn, verifying that idle RPM returns to the
recommended setting. If idle speed increases, it may be necessary to
increase the gap between the stop pin and throttle arm, but do not exceed
the recommended 2-3 mm gap.
8. When adjustments are complete, tighten the locknut.
9. Squeeze the end of the rubber boot and slide it over the cable adjuster to its
original position.
10. Ensure the control cover seal is in place, then reinstall the cover and screws.
101
MAINTENANCE
Loading ...
Loading ...
Loading ...