Loading ...
Loading ...
Loading ...
If needed (when overtaking for instance),
you can accelerate beyond the set speed
by pressing the accelerator. When you
release the pedal, the vehicle will return
to the previously set speed.
When traveling downhill with the system
active, the vehicle speed may slightly
exceed the set one.
Note: Before pushing the SET switch, the
vehicle must be traveling at a constant
speed on a flat surface.
Increasing/Decreasing Speed
Increasing Speed
Once the Speed Control has been
activated, the speed can be increased by
pushing the SET switch upward.
By keeping the switch pushed, the set
speed will increase until the switch is
released. The new speed will then be set.
At every movement of the SET switch,
the set speed can be adjusted.
Decreasing Speed
When the system is active, to reduce the
speed, push the SET switch downward.
By keeping the switch pushed, the set
speed will decrease until the switch is
released. The new speed will then be set.
At every movement of the SET switch,
the set speed can be adjusted.
Note: Moving the SET switch allows to
adjust the speed according to the
selected unit of measurement set on the
Information and Entertainment System
(see dedicated supplement).
Accelerating When Overtaking
Press the accelerator as you would
normally. When the pedal is released, the
vehicle will return to the set speed.
Use Of The Feature On Hilly Routes
The system can automatically downshift
to keep the set speed when driving on
hilly routes.
On steep grades, the loss or gain in speed
may be considerable and is advisable to
deactivate the Speed Control.
Note: The system keeps the speed set
even uphill and downhill. A slight variation
in the speed on slight rises is completely
normal.
Recalling The Speed
Once the system has been deactivated,
but not canceled, the previously set
speed can be recalled by pushing the RES
button and removing your foot from the
accelerator. The system will be set to the
last stored speed.
Note: Before resuming the previously
set speed, you must accelerate to a
speed close to that speed.
In Autostick (sequential) mode, before
resuming the previously set speed, you
should accelerate until you are close to
that speed. Then, push and release the
RES button.
07146S0002EM
SET Switch Location
07146S0003EM
Resume Button Location
154
STARTING AND OPERATING
Loading ...
Loading ...
Loading ...