Loading ...
Loading ...
Loading ...
EN7
REPLACING THE LAMPS
The hood is equipped with an LED lighting system.
LEDs ensure excellent illumination, have a service life up to 10 times longer than traditional bulbs, and oer up to 90%
energy savings.
To replace a lamp, proceed as follows:
1. Remove the grease lters.
2. Access the lamps from inside the hood.
3. Press the release clips to release the lamp.
4. Remove the lamp from the hood frame.
5. Disconnect the terminal.
Proceed in reverse order to t the replacement lamp.
NB: To purchase an LED lamp, please contact the Technical After-sales Service Centre.
MATERIALS SUPPLIED
Remove all the components from the packages. Check that all the components are included.
• Assembled hood with motor, bulbs and grease lters tted (1 or 2 grease lters depending on the model).
• Installation and operating instructions
• 1 x mounting template
• 1 x Torx T10 adapter
• 1 x Torx T20 adapter
• 1 x deector
• 5 x wall plugs, dia. 8 mm
• 5 x screws dia. 5x45
• 3 x screws dia. 3.5x9.5
• 1 x washer dia. 5.3x2
• 1 x cable clamp
• Power cable
• 2 x deectors
• 1 x telescopic chimney section
• 1 x chimney support bracket
INSTALLATION – PRELIMINARY FITTING INSTRUCTIONS
The hood is designed for installation in "lter mode".
Filter mode
The air is ltered as it passes through one or more carbon lters and is recycled back into the atmosphere.
IMPORTANT: Check that the air recirculation process runs smoothly.
If the hood does not have the carbon lter(s), order one/them and t before use.
The hood must be tted away from very dirty areas, windows, doors and sources of heat.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualied technician must ensure that the materials are
suitable for the type of wall/ceiling in question.
INSTALLATION DIMENSIONS
Side units Side units
min. 880 mm
Central line
65 cm (gas or mixed stoves)
40 cm (electric stoves)
Hob surfaces
Loading ...
Loading ...
Loading ...