Loading ...
Loading ...
Loading ...
EN4
Declaration of Conformity
• This product has been designed, manufactured and marketed in compliance with:
- the safety provisions of the “Low Voltage” Directive 2014/35/EU;
- the ecodesign requirements of European Regulations no. 65/2014 and no. 66/2014, in compliance with European standard EN 61591;
- the protection requirements of the “EMC” Directive 2014/30/EU.
The appliance's electrical safety can only be guaranteed if it is correctly connected to an approved earthing system.
Energy saving tips
• Switch on the hood at the lowest speed setting when you start cooking and allow it to run for a few minutes after you have nished cooking.
• Only increase the speed if there is a lot of smoke or steam and only use the "Boost" setting(s) in extreme situations.
• Replace the carbon lter(s) when necessary, to maintain ecient odour reduction.
• Clean the grease lter(s) when necessary, to maintain eciency.
• Use a pipe with the maximum diameter specied in this manual, to optimise eciency and reduce noise levels to a minimum.
INSTALLATION
After unpacking the appliance, check that it has not been damaged in transit. In the event of problems, contact the dealer or your nearest After-sales Service. To
prevent any damage, only remove the appliance from its polystyrene base at the time of installation.
PREPARING FOR INSTALLATION
WARNING
this appliance is heavy; the hood must be lifted and installed by two or more people.
The minimum distance between the pan support on the hob and the bottom of the hood must be no less than 40 cm for electric hobs and 65cm for gas or mixed
hobs.
Before installation, also check the minimum distances specied in the hob manual.
If the installation instructions for the hob specify a greater distance between the hob and the hood, this distance must be observed.
ELECTRICAL CONNECTION
Check that the voltage specied on the appliance identication plate is the same as the mains voltage.
This information is found on the inside of the hood, under the grease lter.
The power cable (type H05VV-F 3x0.75mm
2
) must only be replaced by an authorised electrician. Contact an authorised Service Centre.
If the hood is tted with an electric plug, connect the appliance to a socket which complies with current regulations and which is in an accessible location. If no plug
is tted (direct wiring to the mains), or if the socket is not in an accessible location, install a standardised two-pole circuit breaker that will allow complete isolation
from the mains in the event of category III overvoltage, in compliance with the wiring regulations.
If the cable is not tted with a plug, connect the wires according to the following table:
Mains voltage and
frequency
Wire connection
220-240V – 50Hz
: yellow/green
N : blue
L : brown
GENERAL RECOMMENDATIONS
Before use
Remove any protective cardboard, transparent lm and adhesive labels from the accessories. Check whether the appliance has been damaged in transit.
During use
Do not place heavy items on the appliance as this may cause damage. Do not expose the appliance to atmospheric agents.
Loading ...
Loading ...
Loading ...