Loading ...
Loading ...
Loading ...
29
TROUBLESHOOTING
ENGLISH
Checking error messages (cont.)
Message
Possible Causes Solutions
The display shows:
The washer has detected an out of balance
y
load.
If the washer detects a load that is too far out of
y
balance to spin, it will display this code while it is
attempting to rebalance the load. The washer will add
water and try to redistribute the load automatically.
This display is for your information only, and no action
is required.
The display shows:
If the uE rebalance (see above) is not
y
successful, this error will be displayed.
The load is too small.
y
Heavy articles are mixed with lighter items.
y
The load is out of balance.
y
The automatic attempt to rebalance the load was not
y
successful. The cycle has been paused to allow the
load to be manually adjusted.
Small loads may need additional items to be added to
y
allow the washer to balance the loads.
The load may have heavy items loaded with lighter
y
items. Always try to wash articles of somewhat similar
weight to allow the washer to evenly distribute the
weight of the load for spinning.
Manually redistribute the load if articles have become
y
tangled preventing the automatic distribution from
working properly.
The display shows:
Thermistor error
y
Unplug the washer and call for service.
y
The display shows:
The water level sensor is not working
y
correctly.
Close the water taps, unplug the washer, and call for
y
service.
The display shows:
Thermal overload protection circuit in the
y
motor has been tripped.
Allow the washer to stand for 30 minutes to allow the
y
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call
for service.
Wrinkling
Washer not unloaded promptly.
y
Washer overloaded.
y
Hot and cold water inlet hoses are
y
reversed.
Always remove items from the washer as soon as the
y
cycle is completed.
The washer can be fully loaded, but the drum should
y
not be tightly packed with items. The lid of the washer
should close easily.
Hot water rinse can set wrinkles in garments. Check
y
the inlet hose connections.
NOTE
If an error message is displayed for 4 minutes, the water in the tub will automatically drain. An alarm will sound 1 minute
y
prior to draining, and ‘dr’ will appear on the display. You may restart the washer at this time. However, once the washer
initiates draining, all functions will be suspended, and ‘dr’ will be displayed until draining is complete.
Loading ...
Loading ...
Loading ...