Loading ...
Loading ...
Loading ...
20
Automatic Ice & Water Dispenser
Priming the Water Supply System
1. Begin lling the tank by pressing and
holding a drinking glass against the
water dispenser paddle.
2. Keep the glass in this position until
water comes out of the dispenser. It
may take about 1½ minutes.
3. Continue dispensing water for about
three minutes to ush the system
and plumbing connections of any
impurities (stopping to empty the glass
as necessary).
Ice Maker Operation & Care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours. The
ice maker will ll the ice bin from the rear.
You must dispense some ice to force the ice
forward in the bin. This will allow the bin to
ll completely.
Using the Ice Maker after Installation
Before making ice for the rst time, be sure
to prime the water supply system. Air in new
plumbing lines can result in two or three
empty ice maker cycles. Furthermore, if the
system is not ushed, the rst ice cubes may
be discolored or have an odd avor.
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause water
lter to malfunction.
NOTE
The water dispenser has a built-in device
that shuts o the water ow after three
minutes of continuous use. To reset
this shuto device, simply release the
dispenser paddle.
IMPORTANT
Your ice maker is turned on at the factory
so it can work as soon as you install your
refrigerator. If you cannot connect a
water supply, set the ice maker’s On/O
icon to O and turn o the water supply
valve; otherwise, the ice maker’s ll valve
may make a loud chattering noise when it
attempts to operate without water.
Turning the Fresh Food Ice Maker
On and O
Ice production is controlled by the ice
maker’s On/O icon on the control panel.
Press and hold the “Ice O” icon for three
seconds to turn the ice maker “ON” or
“OFF”. The ice maker is turned o when the
LED above the “Ice O” icon is illuminated.
IMPORTANT
Turning o the ice maker will disable
the ice dispenser. You will still be able to
dispense water.
IMPORTANT
Turning o the ice maker will result in
existing ice melting in the bin.
NOTE
The ice maker also has a built-in plastic
signal bale arm that automatically stops
ice production when the ice bin is full.
This signal arm should not be used to
manually stop the ice maker.
Loading ...
Loading ...
Loading ...