Loading ...
Loading ...
Loading ...
8
Setting Surface Controls
Operating the Single Radiant Surface Elements
The cooktop has 2 (3 on 36” model) single radiant surface elements: the
LEFT REAR & RIGHT REAR (for 30” model) or LEFT REAR, CENTER REAR
& RIGHT REAR (for 36” model) positions (Figures 1 and 2).
To Operate the Single Radiant Surface Elements
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to
the desired setting (Figure 3). Turn the knob to adjust the setting
if desired. Start most cooking operations on a higher setting and
then turn to a lower setting to fi nish cooking. Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is too
small for the surface heating area.
3. When cooking has completed, turn the surface control
knob to OFF before removing the cookware. Note: The Hot
Surface Indicator light will come on when the control knob
is turned on and will continue to glow until the glass cooktop
has cooled down to a moderate level that will not cause
burns if the area is touched. The light may remain on even
though the controls are turned OFF.
Note: See Table on page 7 for recommended control settings.
Radiant surface elements may appear to have
cooled after they have been turned off . A hot surface indicator
light will come on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The glass surface
may still be hot and burns may occur if the glass surface is
touched before the indicator light has turned off .
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on cooktop
when it is in use. These items could melt or ignite. Potholders,
towels or wooden spoons could catch fi re if placed too close to
the surface elements.
Do not allow aluminum foil, or ANY material
that can melt to make contact with the ceramic glass cooktop.
If these items melt on the cooktop they will damage the ceramic
cooktop.
Using Turbo Boil Flex™ Element
The Turbo Boil Flex
TM
feature off ers power to melt, warm,
simmer and boil without moving the pot from element to
element. The Turbo Boil Flex
TM
will bring food items to boil much
quicker and may be used when preparing larger quantities of
food. The cooktop graphics will be clearly marked with this
feature.
Figure 1
Figure 3
Figure 2
HOT SURFACE
TURBO BOIL
FLEX
8
2
4
6
3
7
MED
OFF
LO
HI
8
8
6
6
4
4
2
2
LO
LO
OFF
HI
HI
DOUBLE
SINGLE
3
4
6
7
8
2
TURBO
BOIL
MED
WARM &
SIMMER
OFF
8
8
6
6
4
4
2
2
LO
LO
OFF
HI
HI
DOUBLE
SINGLE
HOT SURFACE
TURBO BOIL
FLEX
3
4
6
7
8
2
TURBO
BOIL
MED
WARM &
SIMMER
OFF
8
2
4
6
3
7
MED
OFF
LO
HI
8
2
4
6
3
7
MED
OFF
LO
HI
8
8
6
6
4
4
2
2
LO
LO
OFF
HI
HI
DOUBLE
SINGLE
8
8
6
6
4
4
2
2
LO
LO
OFF
HI
HI
DOUBLE
SINGLE
TURBO BOIL
FLEX
8
2
4
6
3
7
MED
OFF
LO
HI
Loading ...
Loading ...
Loading ...