Loading ...
Loading ...
Loading ...
Troubleshooting en-us
45
Plastic parts
discolored.
Too low rinsing temperature. Select wash cycle with higher washing tem-
perature.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not pre-rinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Normal"
Removable
streaks on
glasses,
glasses with
metallic
appearance
and silverware.
Too much rinse aid. Set rinse aid amount to lower setting.
No rinse aid added or setting too
low.
Add rinse aid and check dosage (recom-
mended setting 4–5).
Detergent residue in the final rinse
wash cycle section. Detergent dis-
penser cover blocked by dishes
(cover does not open fully).
Detergent dispenser cover must not be
obstructed by dishes.
Do not place dishes or fragrance dispenser
in the detergent tab tray.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not pre-rinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle “Normal”
Initial or exist-
ing, irrevers-
ible clouding of
glass.
Glasses not dishwasher-proof, only
suitable for dishwasher.
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection compo-
nent.
Rust spots on
the silverware.
Silverware not adequately
rust-resistant. Knife blades are fre-
quently more severely affected.
Use corrosion-resistant silverware.
Silverware will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil bas-
kets, etc.).
Do not wash rusting parts.
Salt content in the rinsing water too
high, as salt dispenser lock not fas-
tened firmly or salt was spilled while
being refilled.
Fasten salt dispenser lock firmly or remove
spilled salt.
Dishwasher
cannot be
switched on or
operated.
Malfunction. Disconnect dishwasher from the power sup-
ply; pull out the power supply plug or switch
off the fuse. Wait at least 5 seconds, then
connect the dishwasher to the power sup-
ply.
Fault Cause Remedial action
* This is an optional feature which may or may not be included with your dishwasher.
Loading ...
Loading ...
Loading ...