HT 65
EN Wave styler
Instructions for use ..............................4
EN Unfold page 3 before reading the instructions for use.
1
54
3
6
8
9
10
7
11
2
4
ENGLISH
Read these instructions for use carefully. Observe
the warnings and safety notes. Keep these inst
-
ructions for use for future reference. Make the in-
structions for use accessible to other users. If the
device is passed on, provide the instructions for
use to the next user as well.
Included in delivery
Check that the exterior of the cardboard delivery packaging is intact and make
sure that all contents are present. Before use, ensure that there is no visible da-
mage to the device or accessories and that all packaging material has been re-
moved. If you have any doubts, do not use the device and contact your retailer or
the specified Customer Service address.
1 x Wave styler
1 x Set of these instructions for use
1. Signs and symbols ..........................6
2. Intended use ....................................7
3. Device description ...........................7
4. Usage ..............................................8
4.1 Starting the application ............8
4.2 After use .................................11
5. Cleaning and maintenance ............11
6. Disposal .........................................12
7. Technical data ...............................12
8. Warranty ........................................12
Table of contents
4 5
WARNING
• The device is only intended for domestic/private use, not
for commercial use.
• This device may be used by children over the age of 8 and
by people with reduced physical, sensory or mental skills
or a lack of experience or knowledge, provided that they
are supervised or have been instructed on how to use the
device safely, and are fully aware of the consequent risks
of use.
• Children must not play with the device.
• Cleaning and user maintenance must not be performed by
children unless supervised.
• If the mains connection cable of this device is damaged,
it must be replaced by the manufacturer, its customer ser
-
vice department or a similarly qualified person to avoid
any risk.
• When using the device in the bathroom, unplug the mains
plug after use, as water in the vicinity constitutes a danger,
even when the device is switched o.
• Never use the device near baths, wash basins, showers
or other objects containing water or other liquids – risk of
electric shock!
• As an additional safety measure, we recommend the in
-
stallation of a residual-current circuit device (RCD). The
rated operational current should not exceed 30 mA in the
bathroom circuit. Your local electrical specialist can provi
-
de you with the relevant information.
6
1. SIGNS AND SYMBOLS
The following symbols are used on the device, in these instructions for use, on the
packaging and on the type plate for the device:
Warning
This device must not be used near water or in water (e.g.
in a wash basin, or in the shower or bath) – risk of electric
shock!
Warning
Warning notice indicating a risk of injury or damage to health
Important
Safety note indicating possible damage to the device/
accessory
Note Important information to note
Protection class II
Separate the packaging elements and dispose of them in accordance
with local regulations.
B
A
Marking to identify the packaging material.
A = Material code, B = Material number:
1-7 = Plastics, 20-22 = Paper and cardboard
Separate the product and packaging elements and dispose of them
in accordance with local regulations.
Disposal in accordance with the Waste Electrical and Electronic
Equipment EC Directive – WEEE
Read the instructions for use
CE labelling
This product satisfies the requirements of the applicable European
and national directives.
United Kingdom Conformity Assessed Mark
6 7
Manufacturer
2. INTENDED USE
The wave styler must only be used by individuals for shaping and styling and
is for personal use only! Do not use the wave styler on synthetic hair or on
animals.
Warning
The device is suitable only:
• for external use.
• for the intended purpose and as specified in these instructions for use.
Any improper use may be dangerous!
3. DEVICE DESCRIPTION
1
Dial for setting the wave size
7
Handle
2
Heating rods
8
360° swivel joint
3
+ Button for increasing the temperature
9
Hanging loop
4
- Button for reducing the temperature
10
Mains cable
5
ON/OFF button
11
Transport lock
6
LED temperature display (°C)
8
4. USAGE
4.1 Starting the application
1. Dry your hair thoroughly before using the wave styler.
2.
Make sure that your hair is clean and free from
styling products. This excludes special prod-
ucts designed to help your hair when shaping
curls or waves.
3. Comb your hair to get rid of any tangles.
4. Switch on the wave styler by pressing the ON/OFF button [5].
5. To make it easier to set the temperature, first close the wave styler and slide
the transport lock [11] to the position. Set your desired temperature setting
using the - button [4] or + button [3]. The device is pre-set to 160°C when it is
switched on. Once you have set the temperature, slide the transport lock [11]
to the position. The respective temperature setting starts to flash white in
the LED temperature display [6]. Once the temperature setting lights up white
permanently, the heating rods [2] have reached the configured temperature
setting and the wave styler is ready for use. The button lock can be activated
by pressing the minus button [4] for 3 seconds. A red LED appears in the LED
temperature display [6]. To cancel the button lock, press the minus button [4]
again for 3 seconds. The red LED goes out in the LED temperature display
[6]. The button lock is now deactivated again.
8 9
6.
Separate your hair into individual sections
with a width of approx. 2-4 cm. Hold the
strands taut.
7.
Place the section of hair between the heating
rods [2] starting at the roots. Make sure that
you do not touch your scalp with the heating
rods [2].
Note
First press the dial [1] down and then turn it
to the left or right to set your desired wave
size.
The following styles can be set:
Beach waves
Natural waves
10
Mermaid waves
Water waves
8.
Press the handle [7] of the wave styler shut so
that the hair section is enclosed by the heating
rods. Exert a small amount of pressure and
hold this position for a few seconds.
9.
Release the handle [7] of the wave styler.
Place the wave styler a little lower on the hair
section so that the part that has already been
styled is not done again. Repeat the applica-
tion along the entire length of the hair section.
10 11
Note
The wave styler features a safety switch-o function. If you want to use the
wave styler for longer than 30 minutes, switch the device o and then imme-
diately on again. The safety switch-o function is then reset to activate again
in 30 minutes.
4.2 After use
1. To switch o the wave styler after use, hold down the ON/OFF button [5] for
three seconds. The heating rods [2] are now switched o and the LED temper-
ature display [6] goes out.
2. Pull the mains plug out of the socket after each use.
Do not wind the mains cable [10] around the device!
3. Place the wave styler on a stable, horizontal and non-flammable surface to cool
down. Make sure that the hot heating rods [2] do not touch the surface! Risk of fire!
4. Wait until the heating rods [2] of the wave styler have cooled down completely.
Then store the wave styler in a dry place out of the reach of children. Alterna-
tively, you can hang up the wave styler on a hook using the hanging eyelet [9].
5. CLEANING AND MAINTENANCE
Important
• Always pull the mains plug out of the socket before cleaning the device. Risk
of electric shock!
• Do not clean the wave styler with highly flammable liquids. Risk of fire!
Warning
• Ensure that no water gets inside the device! Risk of electric shock!
12
6. DISPOSAL
For environmental reasons, do not dispose of the device in household waste at
the end of its service life. Dispose of the device at a suitable local collection or
recycling point in your country. Observe the local regulations for material dispos-
al. Dispose of the device in accordance with EC Directive – WEEE (Waste
Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible
for waste disposal.
You can obtain the location of collection points for old devices from the local or
municipal authorities, local waste disposal company or your dealer, for example.
7. TECHNICAL DATA
Weight: Approx. 660 g
Voltage supply 220-240 V~, 50-60 Hz
Power consumption 120 W
Protection class
II
Ambient conditions Only approved for indoors
Permissible temperature
range
-10 to +40°C
Subject to technical changes.
8. WARRANTY
Further information on the warranty and warranty conditions can be found in the
warranty leaflet supplied.
Subject to errors and changes
12 13
14
594.23_HT65_2024-01-19_04_IM1_BEU_EN
Beurer GmbH • Söflinger Str. 218 • 89077 Ulm (Germany)
www.beurer.com • www.beurer-healthguide.com
www.beurer-gesundheitsratgeber.com
