JCHR35W33-2/16
Hand-held 2/16-channel LED Remote
Controller User Manual
JCHR35W33-16
Hand-held 16-channel
LED Remote Controller
JCHR35W33-2
Hand-held 2-channel
LED Remote Controller
JCHR35W33-16
Hand-held 16-channel
LED Remote Controller
JCHR35W33-2
Hand-held 2-channel
LED Remote Controller
JCHR35W33-2/16
Hand-held 2/16-channel LED Remote Controller
CR2032*3V*1
PrgT
When the battery voltage is too low, the LED screen will show “Lo”, prompting to
replace the battery.
01 Product Info
02 Buttons
03 Models & Parameters
(more info please refer to the nameplate)
04 Caution!
05 FCC CAUTION
2-channel
06 Instructions
Note：Channel 0 is the group control for all the channels.
Release it after the
LED flashes 3 times
Note：Channel 0 is the group control for all the channels.
CH- CH+
CH-
CH-
CH+
CH+
CH-
CH+
16-channel
2-channel
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment, this transmitter must not be co-located or operating in conjunction with
any
other antenna or transmitter.
ISED WARNING:
This device complies with Innovation, Science and Economic Development Canada
licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter
tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encomprom-
ettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cetappareilnumérique de la classe B estconformeà la norme NMB-003 du Canada.
Les communications effectuées au moyen de cetappareil ne sont pas nécessairement
protégées des indiscrétions.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment, this transmitter must not be co-located or operating in conjunction with
any
other antenna or transmitter.
Déclarationd'exposition aux radiations: Cetéquipementestconforme aux limitesd'expo-
sition aux rayonnements ISED Canada établies pour unenvironnement non contrôlé.
D O
such as limits setting.
Digital tube flashes
3 times
CH-
CH+
CH-
CH+
16-channel
2-channel
such as limits setting.
T
T
T
T
LED flashes
3 times
16-channel
1. Remove and immediately recycle or dispose of used batteries according to local regulations
and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
2. Even used batteries may causesevere injury or death.
3. Call a local poison control center for treatment information.
4. Compatibel battery type: CR2032
5. Nominal battery voltage: 3V
6. Non-rechargeable batteries are not to be recharged.
7. Do not force discharge, recharge, disassemble, heat above (manufacturer's specified
temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or
explosion resulting in chemical burns.
8. Ensure the batteries are installed correctly according to polarity (+ and -).
9. Do not mix old and new batteries, different brands or types of batteries, such as alkaline,
carbon-zinc, or rechargeable batteries.
10. Remove and immediately recycle or dispose of batteries from equipment not used for an
extended period of time according to local regulations.
11. Always completely secure the battery compartment. If the battery compartment does not close
securely, stop using the product, remove the batteries, and keep them away from children.
WARNING
!
!
•
INGESTION HAZARD: This product contains a
button cell or coin battery.
•
DEATH or serious injury can occur if ingested.
•
A swallowed button cell or coin battery can
cause InternalChemical Burns in as little as
2 hours.
•
KEEP new and used batteries OUT OF
REACH of CHILDREN
•
Seek immediate medical attention if a battery
is suspected to be swallowed or inserted inside
any part of the body.
