4G LTE POC RADIO
DK-Q1
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
SAR tests are conducted using standard operating positions accepted by FCC with the
device transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the actual SAR level
of the device while operating can be well below the maximum value. Before a new model
is a available for sale to sale to public, it must be tested and certified to the FCC that is does
not exceed the exposure limit established by the FCC.
Tests for each product are performed in positions and locations as required by the FCC.
For body worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with and accessory designated for this product or when used with
and accessory that contains no metal.
To maintain compliance with FCC RF exposure guidelines hold the transmitter and
antenna at least 1 inch (2.5 centimeters) from your face and speak in a normal voice, with
the antenna pointed up and away from the face.
4G LTE POC RADIO
LTE Band 2: 1850-1910 MHz(TX),1930-1990MHz(RX)
LTE Band 4: 1710-1755 MHz(TX), 2110-2155MHz(RX)
LTE Band 5: 824-849 MHz(TX), 869-894 MHz(RX)
LTE Band 7:2500-2570 MHz(TX), 2620-2690 MHz(RX)
LTE Band 66: 1710-1780 MHz(TX), 2110-2180 MHz(RX)
USA: LTE FDD, EU: LTE FDD/ LTE TDD
LTE: 2, 4, 5, 7, 66(USA)
LTE FDD: 1,3, 7, 8, 20, 28
LTE TDD: 38, 40(EU)
Note: This equipment has been tested and found to comply with the limits for a Class B
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
