Input
Cable Type-C
Name: Wireless Power Bank
Model NO.: KT11
Battery Type: Lithium Polymer
Material: ABS + PC
USB-C port input: 5VDC,3A/9VDC,2A
Lightning input: 5VDC, 2A
USB-C port output: 5VDC, 2A/9VDC,2.2A
12VDC, 1.67A
USB-C wire output: 5VDC, 2A
USB-A output: 5VDC, 2A
Total output: 5VDC,3A(15W Max.)
Wireless charging output: 15W Max.
Battery Capacity:10000mAh(3.85V 38.5Wh)
Rated Capacity: 6000mAh(5VDC,2A)
Energy Conversion≥60%
Product size: 104x71x19mm
(4.09x2.80x0.74 inch)
Net Weight: 197g/0.43lb
Instructions Manual
16. Operating temperature should be between 10°C to 45°C / 50°F to 113°F
17. Storage Temperature range: -10 to 60 ℃
18. When disposing of secondary cells or batteries, keep cells or batteries
of differnet electronchemical systems separate from each other.
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using this product, basic precautions should always be
followed, including the following:
a) Read all the instructions before using the product.
b) To Reduce the Risk of Injury, close supervision is necessary when the
product is used near children.
c) Do not put fingers or hands into the product.
d) Do not expose power bank to rain or snow.
e) Do not expose power bank to heat or fire. Do not store in direct sunlight or in a vehicle.
f) Use of a power supply or charger not recommended or sold by power
bank manufacturer may result in a risk of fire or injury to persons.
g) Do not use the power bank in excess of its output rating. Overload outputs
above rating may result in a risk of fire or injury to persons.
h) Do not use the power bank that is damaged or modified. Damaged or
modified batteries may exhibit unpredictable behavior resulting in
fire, explosion or risk of injury.
i) Do not disassemble the power bank. Take it to a qualified service person
when service or repair is required. Incorrect reassembly may result in a
risk of fire or injury to persons.
i) Do not expose a power bank to fire or excessive temperature. Exposure
to fire or temperature above 45 ºC can be replaced by the temperature of 113°F.
k) Have servicing performed by a qualified service or repair person using
only identical replacement parts. This will ensure that the safety of the
product is maintained.
l) Switch off the power bank when not in use.
SAVE THESE INSTRUCTIONS
CAUTION:Risk of Fire and Burns.Do Not Open,Crush,Heat Above(45℃)or
Incinerate.Follow Manufacturer's Instructions.
Model NO.: KT11
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
WIRELESS POWER BANK
