Quick Sta Guide
4G LTE Duo Lens Camera
Drilliing Guide
Sticker
Type-C
Built-in
SIM card
OFF/ONDC 5V
Red ashing once per second
Red solid
Communication exception
Waiting for connection
Green continuing ashing
Connecting to seer
Solid green light
Connection successful
PIR sensor triggered
Orange ashing once
Orange Solid
Charging
Red and green lights ash
alternately at a fast rate
Updating
(once eve 0.2 seconds)
Charging
Charge the device via Type-C for 3~5 hours.
OFF/ONDC 5V
OFF/ON
Instructions for wall mounting
Wall Mount or Ceiling Mount
Drill holes in the wall according to the hole spacing on
the camera mount. It is recommended to apply
positioning stickers on the wall to conrm the hole
positions before drilling. Inse the expansion slot into
the hole and screw the camera bracket to the wall.
Back of the mount
Thread the strap through the through-hole on the back
of the camera mount, then secure the strap around the
pole. Tighten the strap to fasten the device securely.
Pole
Instructions for pole mounting
The blue arrow indicates the
strap hole.
The waterproof silicone plug must be installed to prevent
water from entering and damaging the device.
!
49 ft
106°
2MP+2MP,1920*1080*2
90° 49°
49 ft
DC 5V/1.5A or higher
10400 mAh
-4°F to 122°F
32°F to 104°F
FCC Statement
1. This device complies with Pa 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful inteerence,
and
(2) This device must accept any inteerence received,
including inteerence that may cause undesired
operation.
2. Changes or modications not expressly approved
by the pay responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Pa 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful inteerence in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
inteerence to radio communications.
However, there is no guarantee that inteerence will
not occur in a paicular installation. If this equip-
ment does cause harmful inteerence to radio or
television reception, which can be determined by
turning the equipment o and on, the user is
encouraged to t to correct the inteerence by one
or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment
and receiver.
—Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connect-
ed.
—Consult the dealer or an experienced radio/TV
technician for help.
FCC ID:2BU9W-GW-RA
FCC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set foh for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20cm
between the radiator & your body
1. This device complies with Pa 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful inteerence,
and
(2) This device must accept any inteerence received,
including inteerence that may cause undesired
operation.
2. Changes or modications not expressly approved
by the pay responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Pa 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful inteerence in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
inteerence to radio communications.
However, there is no guarantee that inteerence will
not occur in a paicular installation. If this equip-
ment does cause harmful inteerence to radio or
television reception, which can be determined by
turning the equipment o and on, the user is
encouraged to t to correct the inteerence by one
or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment
and receiver.
—Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connect-
ed.
—Consult the dealer or an experienced radio/TV
technician for help.
FCC ID:2BU9W-GW-RA
FCC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set foh for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20cm
between the radiator & your body
suppo@yoosee.com
29
